Etc Eos Titanium, Eos, and Gio v2.0.0 Instrukcja Użytkownika Pobierz pdf (Strona 119)

100

101

6 Patch 101

• {Address} - A required entry field for any device. You may use the either the [At] or [Address/

Patch] key instead of the {Address} button.

• Use the keypad to define the starting address for the device (from 1 to 65536) or a port

and offset value.

• You may enter a start address without defining an end address. Eos will draw this

information from the library data. If you wish to leave a larger output gap than required

by the library, use [Offset]. See Using {Offset} in Patch, page 90.

• If you specify a start address that conflicts with other channels already patched, the

conflicting channels will be unpatched after a confirmation is provided by the user.

• {Interface} - An optional field used to specify what network interfaces should be used for the

output. When the field is left blank, the default data output is used as selected in the

{Network} and {Local I/O} sections of the ECU. For more information about setting defaults

see Output Protocols, page 372 and Local I/O (Eos Ti and Gio Only), page 382. The interface

options available are sACN, Net 2- EDMX, ArtNet, Avab UDP, and Local DMX, depending on

what has been enabled in the {Network} and {Local I/O} sections of the ECU for the desk.

If an output option is not enabled, it will not appear in the {Interface} list.

• {Flash} - will bring a channel or address to full, and then every other second the level will

move to 15%. That will hold for 1 second, and then the level will return to full. The channel or

address will keep flashing until either the command line is cleared or {Flash} is selected

again.

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 475 476

Komentarze do niniejszej Instrukcji

Brak uwag

Etc Eos Titanium, Eos, and Gio v2.0.0 Instrukcja Użytkownika Strona 119

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Panel sterowania Etc Eos Titanium, Eos, and Gio v2.0.0