Etc Source Four LED v1.6.0 User Manual Instrukcja Użytkownika Pobierz pdf (Strona 22)

16 Source Four LED Profile v1.6.0 User Manual

Step 1: Use a Phillips screwdriver to loosen the screws on the drop-in iris slot cover. Do

not remove screws.

Step 2: Slide the cover completely forward to expose the slot.

Step 3: Insert the iris or motorized pattern device. For an iris, install the flat side toward

the shutters and make sure the iris handle extends from the slot.

Step 4: Slide the slot cover back toward the shutters until it meets the iris handle. Leave

enough space to move the iris handle.

Step 5: Secure the accessory slot cover by tightening the screws.

Rotating the Shutter Barrel Assembly

Figure-1.8 Rotating the shutter barrel assembly

Step 1: Loosen the shutter barrel rotation knob directly behind the shutters on the

underside of the reflector housing. Do not remove the barrel rotation knob.

Step 2: Rotate the shutter barrel to the desired position (up to 25° in either direction from

the centered position).

Step 3: Once the shutter barrel is positioned, tighten it’s rotation knob to lock it in place.

Adjusting the C-clamp For North America

Figure-1.9 Adjusting the C-clamp.

The C-clamp attaches the fixture to the mounting pipe and allows fixture adjustments when

mounted.

Barrel rotation knob

C-clamp

Pipe bolt

Pan screw

Yoke bolt and lock

washer

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 99 100

Brak uwag

Etc Source Four LED v1.6.0 User Manual Instrukcja Użytkownika Strona 22