Etc Sensor+ CE Rack (ESR+) CEM+ to CEM3 Retrofit Instrukcja Użytkownika

Sensor Rack (SR and HSR Series) CEM to CEM3 Retrofit ManualRevision A®Copyright © Electronic Theatre Controls, Inc.All Rights reserved.Product informa

8 CEM3 Sensor Rack Retrofit ManualStep 4: Center the provided 4 1/2” x 1/2” dia. heat shrink tubing over the power harness connectors (leaving at leas

2 The Retrofit 9Step 2: Mate the transition cards with the ribbon cable edge connectors as indicated below. Secure the ribbon cable connectors to the

10 CEM3 Sensor Rack Retrofit ManualInstall the New BackplaneStep 1: Ensure the DMX termination switches are set properly. Termination should be turned

2 The Retrofit 11Step 6: Insert the backplane tabs in the sides of the rack.Step 7: With the tabs fully inserted in the sides of the rack, pull the ba

12 CEM3 Sensor Rack Retrofit ManualChange out the Beacon PCBStep 1: Remove the top four dimmer modules from the rack to allow access to the PCB.Step 2

2 The Retrofit 13Verify the RetrofitStep 1: Put the dimmer modules back in the rack in the correct/original order.Step 2: Put the CEM3 in the rack.Ste

Corporate Headquarters  3031 Pleasant View Road, P.O. Box 620979, Middleton, Wisconsin 53562-0979 USA  Tel +608 831 4116  Fax +608 836 1736London,

ETC permits the reproduction of materials in this manual only for non-commercial purposes. All other rights are reserved by ETC.ETC®, and Sensor® are

Introduction 1IntroductionThis manual is intended to guide ETC Service Technicians through the process of upgrading existing Sensor rack installations

2 CEM3 Sensor Rack Retrofit ManualSafetyPlease note the following safety warnings before use:• Disconnect power from the racks before all maintenance.

1 Unpack and Organize 3Section 1Unpack and OrganizeThe table below lists the parts and components needed to retrofit a Sensor rack (SR or HSR 6, 12, 2

4 CEM3 Sensor Rack Retrofit ManualRequired Tools#1 Phillips screwdriver#2 Phillips screwdriver1/4” flat head screwdriverElectrical tapeHeat gunDiagona

2 The Retrofit 5Section 2The RetrofitPreparationStep 1: Use Sensor Configuration Editor and a SLTA if you wish to download and save the current Sensor

6 CEM3 Sensor Rack Retrofit Manualsliding it out of the notch in the rack and carefully pushing it through the backplane metal. This connector will be

2 The Retrofit 7Step 5: Disconnect the DMXA wires from slots 1,2 and 3 of the J2 connector.Step 6: Connect the DMXA wires to an 8-pin connector. DMXA