Etc Sensor3 CE (ESR3) Rack Instrukcja Użytkownika Pobierz pdf (Strona 19)

2 Installation of Racks 11

Rack Cabling Access

ESR3 racks have removable top and bottom access panels.

Conduit Connections

Step 1: Remove the desired access panel from the rack.

Step 2: Cut access holes in the top and bottom access panels.

Step 3: Install your cabling into the holes.

Step 4: Re-install the access panel so that there are minimal air gaps. See “Sealing Rack

Air Leaks” on page 28. for more information

Trunking or Wire Trough Connections

Step 1: Remove the desired access panels.

Step 2: Cut suitable openings to mate with the trunking or trough using a jigsaw or

hacksaw.

Step 3: Reinstall panel on to rack

Step 4: Install a fiche paper lining or grommeting material in the access panel opening.

Step 5: Position the trunking or wire trough above the prepared opening.

WARNING:

Cutting holes in the rack plates in situ may introduce metal debris into the

dimmer cabinet.

Note:

Wire openings must have fittings or linings to protect cable insulation from

damage by sharp metal edges.

Figure 8: ESR3 access panels

Bottom access panel

Top access panel

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 47 48

Brak uwag

Etc Sensor3 CE (ESR3) Rack Instrukcja Użytkownika Strona 19